Добро пожаловать на страницу, где вы можете пройти тест CES онлайн по теме “система АИС”. Данная практика поможет вам, как морскому специалисту, подготовиться к сдаче экзаменов, получению сертификата компетентности или аттестата.
Начать тест
Can AIS with MKD operate as a standalone system?
No.
Yes.
Only in ship to ship mode.
Only in ship to shore mode.
Принять ответ
How is the AIS technical status checked?
Automatically.
Manually.
No check is necessary.
During annual service.
Принять ответ
How is the voyage related information updated?
Automatically.
Manually.
No update is necessary.
Semi-automatically.
Принять ответ
How much can the AIS broadcast mode be overloaded without any significant operational effect?
50-100 %.
200-300 %.
400-500 %.
No overload is accepted.
Принять ответ
How often is the static information updated?
Every 12 seconds.
Every 3 minutes.
Every 6 minutes.
Manual update when necessary.
Принять ответ
In case of AIS overload, what can you expect?
AIS will shut down.
AIS will “freeze”.
Targets far away drop out.
Close targets drop.
Принять ответ
Seen from an operational point of view, how will you describe the AIS?
AIS is a semi-automatic system.
AIS is a manual system.
AIS is an automatic system.
AIS is both manual and automatic.
Принять ответ
The AIS transmitted information is divided into three main groups. Which?
Ship data, Speed data and Course data.
Dynamic data, Static data and Voyage related data.
Dynamic data, Destination data and Cargo data.
Position data, Identity data and Dynamic data.
Принять ответ
The AIS transponder is designed to transmit information:
Automatically.
Semi-automatically.
Manually.
AIS is not transmitting at all.
Принять ответ
The dynamic information update rate depends on:
Ship’s size.
Type of ship.
Type of cargo.
Ship speed and ROT.
Принять ответ
The lost target symbol is shown where?
At the bottom of the screen.
In the last known target position.
At the top of the screen.
In operator defined position.
Принять ответ
The selected target symbol represents:
A manually selected target.
An automatically selected target.
A semi-automatically selected target.
A target lost by the AIS.
Принять ответ
What are the criteria for a dangerous target in AIS?
A target carrying dangerous cargo.
A target calculated to violate preset CPA/TCPA limits.
A target bigger than own ship.
A target faster than own ship.
Принять ответ
What can happen in case of AIS overload?
The system will shut down.
The system will freeze.
The system will give an alarm.
Targets far away will drop out.
Принять ответ
What happens when an AIS sensor fails?
Nothing.
AIS display “not available”.
AIS is automatically switched off.
The AIS calculate the missing data.
Принять ответ
What is the IMO minimum display requirements for AIS?
AIS information on Radar.
AIS information on ARPA.
AIS information on ECDIS.
AIS information on MKD.
Принять ответ
What is the accuracy of the AIS information?
The accuracy is good.
The accuracy is not so good.
The accuracy can be compared with the accuracy of radar.
The accuracy is as good as the accuracy of the transmitted information.
Принять ответ
What is the required minimum ship reporting capacity for AIS according to IMO performance standards?
1 000.
2 000.
4 000.
4 500.
Принять ответ
What kind of system is AIS?
Transponder system.
Radar system.
ECDIS system.
Navigation system.
Принять ответ
When is static information entered into the AIS?
After the voyage is completed.
During installation.
At sea.
At the AIS factory.
Принять ответ
When should the AIS transponder normally be activated?
When the OOW think it is necessary.
In coastal waters.
In open waters.
Always.
Принять ответ
When using AIS the OOW should be aware of?
AIS information is always correct.
AIS information may not be correct.
AIS information is automatically switched off if not correct.
AIS information need to be corrected before use.
Принять ответ
Which of the following is defined as dynamic information?
Ship’s speed over ground.
Ship’s call sign and name.
Ship’s destination and ETA.
Ship’s route plan.
Принять ответ
Which of the following is defined as static information?
Navigational status.
Safety related messages.
MMSI.
Route plan.
Закончить тест
* В некоторых вопросах теста “Система АИС” может быть несколько правильных ответов.

“CES тест” пройден! Ваш результат: